Cap value around MAX77621A south to APU

[mauro2319]

@Severence

Good stuff, getting there!

Sure, after projection, heated floor to install and then concrete floor, tiles and we are good to go for all the smaller stuff.

@Severence

Or it’s false battery drain being misreported as a result of fuel gauge issues, there was a thread recently here where I covered this and a few more serious issues which act like fuel gauge fault symptoms but are quite a bit more serious

Another thing you can do is note the battery percentage in the OS then turn off the unit, wait a few seconds and then prompt it to boot and take a look at the battery percentage again, if it’s not within a couple of percent of your previously noted reading then it’s likely fuel gauge (or the more serious issues mentioned above) which is the problem

I haven’t checked manually the battery voltage yet, but i read the thread you are referring to, it is that one right : Fuel Gauge IC issue but fuel gauge not at fault
What i can tell so far, without having taken a part the console yet since (no time for), is that i don’t have the exact same symptom. I launched Hekate to check, and my fuel gauge is reporting good and valid data. But basically i think the battery drain is gone, afaict i haven’t got it anymore since a couple of days. Now i am left with sometimes the error 21001-001. I will replaced once more the M92 and hope for the best.